setting_mousetraps 202, search v3 new a replay
BEHAVIOR-1K 2026 challenge, issue 74, recov50 scripted recoveries, seed 0, Oct 23 to 29, run v3_new_a
Harm gate: accepted. Nothing fell, tipped or moved more than 0.30 m.
failed The phase is to pick up the mousetrap from the bottom cabinet. The mousetrap was out of view at the restore, and the search found it with the head camera after 14 s. The reach plateaued once and the stall reset fired no times. It ended failed: robot tipped (0.32 rad).
Other search v2 runs of this case: v3c_c, not found, v4_c, not found, v5_c, not found, v5b_on_c, not found, v5b_off_c, not found, v5c_dev, not found, v6_dev, not found, v6b_dev, not found, v6c_dev, pass.
The clips play at 2 times sim speed by default, and the speed menu changes that. The timeline shows the recoverer's stage, whether the target is inside the head camera's view while it reaches (from the gaze log), and the labelled events. Click a row to jump there. The robot panel sums up the attempt and the phases list follows the stages.
- Task
- -
- Instruction
- -
- Step
- -
- Sim time
- -
- Q
- -
- Driving
- -
Timeline
Q over time
Robot
- State
- -
Phases
The instruction follows the current phase and moves on when the phase detector confirms it. A typed instruction overrides it until you go back to the task sentence.
Last command
| part | 1 | 2 | 3 | 4 | 5 | 6 | 7 | gripper |
|---|
Look-around
Events
- Nothing yet.
Stage timeline
| stage | from | to | detail |
|---|---|---|---|
| Search | 0:00 | 0:11 | found by the head camera |
| Drive to the target | 0:11 | 0:14 | |
| Approach | 0:14 | 0:29 | 1 contact |
| Grasp | 0:29 | 0:33 | descend to the grasp |
| Approach | 0:33 | 0:35 | 1 base move, 3 contacts |
| Outcome | 0:35 | 0:35 | failed: robot tipped (0.32 rad) |
Plan and path maps
The plan map is where the search meant to look, from the restore. The path map is where the base went: the search path, then the recovery path.
Earlier attempts
No earlier seed 0 attempt of this case.
All cases. Results come from the attempt's result.json in the recov50 v3_new_a run, seed 0.